Sand Separator

Specifications:

3,000 - 5800 PSI
ASME "U" Stamp, Section VIII, Div 1 Pressure Vessel
Each Vessel National Board Registered
Type L - Skid Vertical Sand Trap
Design: 5,800 PSI MAWP @ 100 Degrees F Pressure: 7,800 PSI Hydrostatic Test
Inlet: 3" 1502 Female (Thread End) Hammer Union
Located on Vessel Side, Below Upper Head
Sand Out: 2-2" 1502 Male (Wing End) Hammer Unions
Located 180 Degrees Apart on Vessel Side Above Bottom Head
Cleanout: 2" 1502 Male (Wing End) Hammer Union
Located on Bottom Center of Bottom Head
Gas Out: 3" 1502 Male (Wing End) Hammer Union
Located on Top Center of Top Head
 

Tiger Safety

Tiger Safety, 1125 Petroleum Parkway, Broussard, LA 70518