15K Sand Trap

Specifications:

Type: L-Skid Vertical Sand Trap
Design Pressure: 15,000 MAWP; 22,500 PSI Hydrostatic Tested
Shell: 17" OD x 9.5" ID x 3/4" Thick Wall; 9'4" Long
Heads: 3" ID x 17" OD x 10.5 Long, SA 350 LF2 Material; 4" ID x 17" OD x 10.5" Long, SA 350 LF2 Material
Welds: FCAW/Semiautomatic, X-Ray Inspected
PWHT: Vessel Post Weld Heat Treated
Inlet: 2" 1,502 WECO Female Hammer Union
Outlet: 2" 1,502 WECO Male Hammer Union
Sand Dump: 2" 1,502  WECO Hammer Union
Valves: 2" Inlet, Outlet, and Bypass Gate Valves; Gate Valve Assembly, Manual Model
SGC-2; 2-1/16" API Flange, API 6A 19th Edition PSL-2
Skid: L Skid Frame w/ Pull Pipe at Top Vessel End; 20' x 5' 9.75 x 6' 11.5"
Weight: Approximately 16,000 lbs.
Certification: Built to API 6A PSL 3 Standards
 

Sand Separator

Specifications:

3,000 - 5800 PSI
ASME "U" Stamp, Section VIII, Div 1 Pressure Vessel
Each Vessel National Board Registered
Type L - Skid Vertical Sand Trap
Design: 5,800 PSI MAWP @ 100 Degrees F Pressure: 7,800 PSI Hydrostatic Test
Inlet: 3" 1502 Female (Thread End) Hammer Union
Located on Vessel Side, Below Upper Head
Sand Out: 2-2" 1502 Male (Wing End) Hammer Unions
Located 180 Degrees Apart on Vessel Side Above Bottom Head
Cleanout: 2" 1502 Male (Wing End) Hammer Union
Located on Bottom Center of Bottom Head
Gas Out: 3" 1502 Male (Wing End) Hammer Union
Located on Top Center of Top Head